How do I set up the Camio Box 1510A?

There are only a few simple steps to finish the setup of the Box 1510A device. These instructions refer to the back of the device.

eno1 is the primary NIC.

enop2s0 is the secondary NIC.

1510A

1510A-rear-ports.jpg

mc610_50_back_1.jpg

Power Supply

The power supply is connected via the "DC IN" port on the back of the device, to the right of the two network interface ports. 

Networking

mc610_50_back_2.jpg
NIC1 (eno1) is red on the left; NIC2 (enop2s0) is white on the right.

The 1510A device comes with dual NICs, these are categorized as "primary" and "secondary" interfaces. The primary interface is on the left, closest to the display ports (the red ethernet cable is attached to the primary NIC in the above photo). The secondary NIC is to the right of that, closest to the "DC IN" power port (the white ethernet cable is attached to the secondary NIC in the above photo). Connect the primary NIC to your WAN and the secondary NIC to your camera LAN via standard Ethernet (Cat6) cables.

Once the power and ethernet connections are made your Camio Box is ready to begin the processing of video streams.  

Have more questions? Submit a request

Comments